Pulling graphite shafts

[Wildbore]

Hello, I am wondering how I can save a graphite shaft when I pull it. It seems as though whenever I apply heat, the shaft tip area becomes really soft. I am concerned as I don't know whether I am permanantly damaging the shaft, or if the shaft getting soft is just normal.

If the shaft is cheap i cut it and drill the remnants out of the hosel, but I got some expensive shafts I want to reuse in different clubs, and I want to do it right.

[cayrbee]

Re: Pulling graphite shafts

Heat really slow then pull STRAIGHT OUT slowly. Works for me. Patience.

[LowPost42]

Re: Pulling graphite shafts

Rule #1: A good puller saves you time, money, and advil (or aleve).

The the head must not be twisted, under any circumstances. To ignore this is a sure-fire way to compromise the graphite fibers, rendering the pull useless (or 3 wood bound if you're lucky).

What kind of heat are you using, how long are you using it, and how are you using it?

I hear lots of folks like micro torches. I prefer a plumbers torch. I keep it hot, and moving over the hosel. When I clamp the shaft in the puller, I always clamp it toe-away. This serves two purposes. One, it gives me more hosel to work with. Two, it's the backside of the club. If I do happen to scorch something that I can't undo, it doesn't show at address. I heat the side towards me for a 3 count (keep the heat moving). Then the side away for 3. Then the top for 3. Then the bottom for 3. Then I crank the puller a little. Rinse and repeat until the epoxy lets go. I find it imperative to put a little pressure on the head, so that you can see when the epoxy has let go. That way you only use the absolute minimum amount of heat.

What's in my shop? I use the JB Pro Hydraulic puller. Best puller on the market, bar none. Screw-types are ok for a hobbiest, but the minute you nick the paint job on a good shaft, you probably could have paid for the JB.

[golfndawg]

Re: Pulling graphite shafts

Hey LP

Boy did I screw up a graphite shaft by doing the same process as an iron shaft.....I heated it up waiting for some popping noise -a little twisting here and there thinking it was breaking loose ( LOL ) all it was doing was twisting the fibers.Learned a good lesson there..........NEVER TWIST ON A GRAPHITE SHAFT.

[LowPost42]

Re: Pulling graphite shafts

Hey LP

Boy did I screw up a graphite shaft by doing the same process as an iron shaft.....I heated it up waiting for some popping noise -a little twisting here and there thinking it was breaking loose ( LOL ) all it was doing was twisting the fibers.Learned a good lesson there..........NEVER TWIST ON A GRAPHITE SHAFT.

LOL - fortunately for me, I read about not twisting long before I pulled graphite. Steel is fine, but it's just plain wrong for graphite. Still, I have this strange desire to do it, just to see it.