Played 18 yesterday and I played well (I think) except for my short game. On most of the holes I was in position to make GIR, but my chip/pitch shots hit the green and rolled all the way across and off the green. In the past, I either hit these shots short or over the green; now I'm hitting onto the green and they are rolling off. These shots were within 70 yd of the green, and I used either a PW or LW. I liked where the ball initially landed on the green and I want to keep the ball in that area, which was within 5 yd of the hole. Any advice? (Also, I noticed that when I putted that the greens were fast, which hasn't been the case for this course during my previous 4 times playing there.)
Announcement
Collapse
No announcement yet.
Help for chipping onto a "fast" green
Collapse
X
-
GTO Moderator
- Jul 2004
- 5311
-
True Length Technology Fitter - www.truelengthtechnology.com
It's live! - www.ShipShapeClubs.com
PCS Class 'A' Clubfitter
A new highlight: Golfing the home course on Christmas Day.
I say it too often: If it's golf club shaped, you can play with it.
For the record, I'm a club doctor, not a swing doctor.
Re: Help for chipping onto a "fast" green
Well, the obvious answer is adjust. If your chips are running away, either chip with a more lofted club (less run), or land shorter and compensate.
Another consideration are slopes. If you pitch on and hit a downslope, your ball will run further than normal.
A third consideration is identifying the safe zones on the green. Perhaps you had a bunch of tough pins guarded by subtle undulations. Pitch (or chip) to the flat part of the green, then let your flatstick work twice (or once) to finish.
-
Re: Help for chipping onto a "fast" green
Originally posted by LowPost42Well, the obvious answer is adjust. If your chips are running away, either chip with a more lofted club (less run), or land shorter and compensate.
Another consideration are slopes. If you pitch on and hit a downslope, your ball will run further than normal.
A third consideration is identifying the safe zones on the green. Perhaps you had a bunch of tough pins guarded by subtle undulations. Pitch (or chip) to the flat part of the green, then let your flatstick work twice (or once) to finish.Last edited by cb44; 03-19-2006, 06:26 PM.
Comment
-
Re: Help for chipping onto a "fast" green
Just a thought on my part. Did the course conditions/lay out not allow for a bump, and run shot? Sounds silly I know, since you are already trying to stop a ball on a fast green with higher shots, but in some instances running the shot up to the green will slow the ball down before it gets on the green.
Perhaps another option would be to use more of a flop shot than a chip, or pitch. A ball falling with more of a straight down fall will move less after impact on most greens.
There is hole on my home course that the green is raised, and slopes away from approach shots. I use to lay up, and try to stop the ball on the green with my next shot, while hoping for a one putt par. I found a better way, which was to fly the ball past the green giving me two up hill shots to work with for par. Just some thoughts to ponder. GJS
Comment
-
Re: Help for chipping onto a "fast" green
I was going to mention the ball, but also you might want to play to a yardage where you can hit a full wedge. Partial shots just do not let you spin the ball enough to stop it some times. While a full wedge should maximize the spin throw the ball higher and help it stop sooner.
Bob
Comment
Comment