Announcement

Collapse
No announcement yet.

Drilled a hole in a R7

Collapse
X
Collapse
 
  • Page of 1
  • Filter
  • Time
  • Show
Clear All
new posts
Previous template Next
  • #1

    Drilled a hole in a R7

    I was looking to buy a new driver, while browsing the net i found a guy selling a taylormade R7.it had been making a rattling noise due to a small piece of metal inside. when he gave it to his pro, he drilled a hole in it to get out the piece of metal that was making the noise. my question is. does this affect the club in any way?
    Tags: None
  • #2
    Re: Drilled a hole in a R7

    hi
    i would think so as a few grams make a diffrence in setting up a driver head. have you tried it.
    bill

    Comment

    • #3
      Re: Drilled a hole in a R7

      drilling a hole in it is not going to make a difference, you would have to remove 20 to 30 grams of weight to notice a difference, as for strength no need to worry

      Comment

      • #4
        Re: Drilled a hole in a R7

        Some Pro...........!!!!!,


        A good pro would have removed the shaft to get it out then put it back in...............no hole.


        Depending on the hole size and where the hole is depends on how it will effect it, hence movable weights.

        My advice steer clear.


        Ian.

        Comment

        • #5
          Re: Drilled a hole in a R7

          he drilled a 4mm hole in the sole of the club. after your comments regarding the effects on the clubhead i dont think i will be pursuing this one.thanks for the advice folks i will just have to forget it and look somewhere else.

          cheers

          Comment

          Previous template Next
          Working...
          X